IMPORTANT
The following information pertains to the SECURITY of your program. This section
should be read and fully understood before attempting to install your DLS-1 Software.
You will be asked for an 8 digit security stamp when installing the program. Write this
stamp down in the space provided on the next page and keep it in a safe place. This
security code is used to stamp all of your Customer Work Files. This means that your
Customer Work Files can only be used on a system that has been installed with the
same stamp. This stamp must be 8 characters long or you will be asked to re-enter
it. The stamp can be made up of any combination of numbers, letters or characters.
Note that all letters are case sensitive; that is, “A” is
not
the same as “a”. If you plan
on running the DLS-1 Software on more than one computer, the Security Stamp used
during installation must be the same on all computers. This will allow you to transfer
Customer Work Files from one computer to another.
The “DSCINST” routine must be used every time the DLS-1 Software is installed.
If you routinely run programs that optimize the performance of (defragment) your hard
drive (eg. the Norton Utilities Speed Disk program), when you next run the DLS-1
Downloading Software, you will get an error message explaining that the security of
the software has been tampered with. At the point of the error message, you will be
asked to enter your 8 character Security Stamp. If you enter the correct stamp, the
program will re-initialize itself, and it will then function normally.
NOTE: If you have installed the software before, it is very important that you answer
“NO” when asked if you wish to delete the present customer work files. If you do not
answer “NO”, you will lose all of your customer work files.
NOTE: If you will be running on a local area network (LAN), all DLS-1 installations
MUST have the same Security Stamp in order to share workfiles. Please see section
1.1.3 in this manual for more information.
v
Kommentare zu diesen Handbüchern