Digital Security Controls PC1575 Installationshandbuch PDF herunterladen (Seite 33)

2.2 Run the DLS-1 Software

If you are not already in the installed directory, type:

[CD\] [name of the directory where the DLS-1 software is installed],

then press [ENTER].

Now type [DSC] to start the DLS-1 software. If you are using PC-Link, type [DSCLINK]

instead. (You can also switch between modem and PC-Link modes using the

PC5015, PC5010 v2.0, PC5008, PC1575/1580, PC1565-2P, PC1555/1565, PC580/

585 “Downloading/Uploading Control” menu.)

The DLS-1 software will first try to initialize the modem. If the modem does not initialize

properly, a warning message will be displayed. You will be asked if you wish to return

to DOS (press [ESC]), or if you wish to view a help message which will list possible

explanations for the modem’s failure to initialize. Press [Y] to view the help message,

or press any other key to continue on with the DLS-1 software.

If the problem is in the DLS-1 program configuration, the modem can be initialized

at a later time when the configuration is changed.

If you are using PC-Link, no modem initialization is performed.

NOTE: If screen errors are encountered while running DLS-1 in Windows, make sure

that DLS-1 is running in a maximized window.

2.3 Log On

The DLS-1 program will display the title screen and a menu asking if you wish to Log

On (press the [L] key), or if you wish to exit to DOS (press the [E] key). A window will

appear and ask for your access code.

If this is the first time you are running the DLS-1 software, you must use the default

access code, which is [1234]. When prompted, enter this code, or any other code

you may have previously programmed. If you enter a valid code, the screen will

display “Operator Access Granted To” followed by the name of the operator. This

message will be flashing. If you used the default access code to log on, the operator

name will be “DSC DEFAULT”.

If you enter an invalid code the message will read “ACCESS DENIED”. You will then

be given another attempt to enter a correct code. If you are unable to enter a valid

code, press [ESC] at the Access Code entry prompt then select “Exit to DOS” (press

[E]) and you will be returned to DOS. You only have three chances to enter a valid

access code before the program is terminated.

Once a valid code has been entered, you will go directly to the Main Menu.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 109 110

Keine Kommentare

Digital Security Controls PC1575 Installationshandbuch Seite 33